|
|

Gas Main Purging And Commissioning Magma Energy Services Ltd carries out Gas Main Purging and Gas Main Commissioning.
Safe Gas Main Purge The destination end is connected to the purge point shown above by flexible hose. The source of the main is connected to the Purge Fan. Operative use 2 Way Radio to communicate. When the fan is turned on fresh air is forced down the gas main which begins to purge the gas from the pipe. The gas flows out of the gas main, down the hose, through the purge rig and into the atmosphere.
A gas analyser shows the level of gas in the purging mixture. When the mixture reads only oxygen, the main is purged and can safely be removed. A special procedure applies to mains with T's to ensure 100% gas removal. The flare point is an approved flare and can support safe burning of the gas should the discharge become ignited. Commissioning When the new gas main has been connected and pressure tested, the purge equipment is connected to the main. The volume flow meter on the purge kit is reset and the gas is turned on. The main is safely purged until the volume of air in the main is replaced with gas, hence the need to identify the volume before starting work. The gas analyser can be used to confirm that the purge of air. Certification Health & Safety Construction Site Safety Tuesday 1st November 2011 |